TM 9-2320-272-10
2-104
NOTE
If CTIS is not operational, refer
to paragraph. 3-16.
a.
Hwy Mode.
CTIS highway
selection is automatically programmed
Hwy (4) when you start the engine.
b.
X-C Mode.
When the mission
requires off-road driving, select X-C (cross-
country) by depressing X-C (3) on the
selector panel (1).
c.
Sand Mode.
When the mission
requires driving in sand, snow, or mud,
select SAND by depressing SAND (2) on
the selector panel (1).
WARNING
Do not put vehicle in motion until warning light goes out and alarm
(buzzer) stops sounding. Air pressure gauge should indicate at least
90 psi (621 kPa). If warnings continue beyond three minutes, and/or
pressure gauge does not reach 90 psi (621 kPa), turn ignition switch
and battery switch to OFF positions and notify your supervisor.
Failure to do this may cause injury or death.
a.
Be sure all auxiliary equipment and tools are stored and locked.
b.
Start engine. Refer to paragraph 2-12 for instructions.
c.
Set vehicle lights for operating conditions. Refer to paragraph 2-18 for light
switch operating instructions.
CAUTION
Do not shift transfer case shift lever from high range to low range,
or low range to high range, unless transmission selector lever is in
N (neutral).
d.
With transmission selector lever (2) in N (neutral), select transfer case
driving range:
(1)
Depress lockout switch (1) and place transfer case shift lever (3) down to
HIGH range for normal driving conditions.
2-15. PLACING VEHICLE IN MOTION
2-14. CTIS OPERATION