TM-9-2320-272-23-3
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-3 - Page 1448 of 1469
INSTALLATION
1.
Position door glass (Figure 4, Item 7) in cab door (Figure 4, Item 4) so regulator channel (Figure 4, Item 6) is
accessible through door inspection hole (Figure 4, Item 5).
2.
Place two window regulator arm studs (Figure 4, Item 9) in regulator channel (Figure 4, Item 6) and install with
two fasteners (Figure 4, Item 8).
3.
Install two window regulator stop brackets (Figure 4, Item 3) on regulator channel (Figure 4, Item 6) with four
lockwashers (Figure 4, Item 2) and screws (Figure 4, Item 1).
NOTE
If adjustment is not required, skip Steps (4) and (5).
4.
To adjust, raise door glass (Figure 4, Item 7) to full up position.
5.
Lower door glass (Figure 4, Item 7) and tighten four screws (Figure 4, Item 1).
M5212DAA
3
2
1
7
6
5
3
4
8
9
6
Figure 4.
Cab Door Glass Installation.
END OF TASK
FOLLOW-ON MAINTENANCE
Install cab door inspection hole cover. (WP
0550)
END OF TASK
END OF WORK PACKAGE
TM 9-2320-272-23-3
0552
0552-7/8 blank
Back to Top
