TM-9-2320-272-23-3

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5

SEPTEMBER 2012

TM-9-2320-272-23-3 - Page 97 of 1469

INSTALLATION

CAUTION

Do not install wiring harness to hood retaining rod mounting bracket screw. Movement will

cause clamp to cut harness.

NOTE

M936 vehicles use only eight screws and clamps for Step (1).

1.

Route cable (Figure 3, Item 1) along perimeter of grille (Figure 3, Item 6), and install ten clamps

(Figure 3, Item 2) on vehicle (Figure 3, Item 5) with screws (Figure 3, Item 4) and locknuts

(Figure

3,

Item

3).

2.

Connect connector (Figure 3, Item 7) to blackout lamp (Figure 3, Item 8).

NOTE

Left and right headlamps are installed the same. Steps (3) and (4) cover the right headlamps.

3.

Connect connectors (Figure 3, Items 13 and 14) on right headlamp (Figure 3, Item 15).

4.

Connect connector (Figure 3, Item 16) on right headlamp (Figure 3, Item 15) and secure eye end of ground

wire (Figure 3, Item 11) to panel (Figure 3, Item 17) with lockwasher (Figure 3, Item 12), washer

(Figure

3,

Item

10), and screw (Figure 3, Item 9).

TM 9-2320-272-23-3

0356

0356-6