TM-9-2320-272-23-4

TM-9-2320-272-23-4 - Page 899 of 1393

DISASSEMBLY - Continued

23.

Using soft-head hammer, tap on end of worm shaft (Figure 5, Item 16) to drive bearing (Figure 5, Item 2) from

bore of gearcase (Figure 5, Item 1).

24.

Using puller, remove bearing (Figure 5, Item 2) from worm shaft (Figure 5, Item 16).

25.

Align bearing (Figure 5, Item 15) with bore of gearcase (Figure 5, Item 1). Using softhead hammer, tap opposite

end of worm shaft (Figure 5, Item 16) and remove worm shaft (Figure 5, Item 16) with bearing from gearcase.

26.

Use puller or arbor press to remove bearing (Figure 5, Item 15) from worm shaft (Figure 5, Item 16).

27.

Remove screw (Figure 5, Item 11), lockwasher (Figure 5, Item 10), and washer (Figure 5, Item 9) from drum

shaft (Figure 5, Item 14) and cover (Figure 5, Item 4). Discard lockwasher.

28.

Remove four screws (Figure 5, Item 6) and lockwashers (Figure 5, Item 7), screws (Figure 5, Item 5), cover

(Figure 5, Item 4), and gasket (Figure 5, Item 3) from gearcase (Figure 5, Item 1). Discard lockwashers

and

gasket.

29.

Remove seal (Figure 5, Item 8) from cover (Figure 5, Item 4). Discard seal.

30.

Using softhead hammer, tap on drum end of drum shaft (Figure 5, Item 14) to remove drum shaft and worm

gear (Figure 5, Item 12) from gearcase (Figure 5, Item 1).

31.

Using arbor press, remove worm gear (Figure 5, Item 12) from drum shaft (Figure 5, Item 14).

32.

Remove two woodruff keys (Figure 5, Item 13) from drum shaft (Figure 5, Item 14). Discard woodruff keys.

TM 9-2320-272-23-4

0696

0696-10