TM-9-2320-272-24-2

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL; VOLUME 2 OF 4

JUNE 1998

TM-9-2320-272-24-2 - Page 226 of 991

TM 9-2320-272-24-2

3-327. FRONT WINCH CABLE REPLACEMENT

THIS TASK COVERS:

a Removal

b. Installation

INITIAL

SETUP:

APPLICABLE

MODELS

All with winch

TOOLS

EQUIPMENT CONDITION

l

Parking brake set (TM 9-2320-272-10).

l

Front winch cable unwound (TM 9-2320-272-10).

l

Cable chain and hook removed (para. 3-325).

General mechanic ’s tool kit (Appendix E, Item 1)

GENERAL SAFETY INSTRUCTIONS

REFERENCES (TM)

Wear hand protection when handling winch cable.

TM 9-2320-272-10

TM 9-2320-272-24P

WARNING

Wear hand protection when handling winch cable. Broken wires

may cause injury to personnel.

a. Removal

1.

Remove setscrew (1) and winch cable (4) from hole (3) in winch drum (2).

NOTE

Perform step 2 if front winch is equipped with level wind and

tensioner.

2.

Pull winch cable (4) out at side roller (9), over level wind pulley (6), down through tensioner

sheaves (7), and out of rollers (8) and (9).

b. Installation

NOTE

Perform step 1 if front winch is equipped with level wind and

tensioner.

1.

Thread winch cable (4) into center of rollers (8) and (9), tensioner sheaves (7), under level wind

pulley plate (5), and over level wind pulley (6).

2.

Insert winch cable (4) in hole (3) of winch drum (2) and install setscrew (1).

3-834