TM-9-2320-272-24-2

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL; VOLUME 2 OF 4

JUNE 1998

TM-9-2320-272-24-2 - Page 626 of 991

TM 9-2320-272-24-2

3-453. PRESSURE TRANSDUCER REPLACEMENT (Contd)

b. Installation

1.

Install pressure transducer (11) on pneumatic controller (5) and connect wire (10) to pressure

transducer (11).

NOTE

2.

3.

Perform steps 2 and 3 for vehicles without PTO.

Remove three screws (1) from mounting plate (3) and cab floor (4).

Install cover (2) on mounting plate (3) and cab floor (4) with three new lockwashers (6) and

screws (1).

NOTE

4.

5.

Perform steps 4 through

10

for vehicles equipped with PTO.

Remove three screws (8) from mounting plate (3) and cab floor (4).

Install PTO control panel assembly (9) on mounting plate (3) and cab floor (4) with three new

lockwashers (7) and screws (8).

6.

7.

Install clevis (21) on shift lever (14) with clevis pin (13), washer (22), and new cotter pin (12).

Install front winch control cable (18) on bracket (16) with spacer (17), clamp (20), two screws (19),

and nuts (15).

8.

9.

Install clevis (28) on shift lever (23) with clevis pin (29), washer (24), and new cotter pin (25).

Install

PTO

control cable (30) on bracket (32) with spacer (33), clamp (34), two screws (35), and

nuts (31).

10.

Install access cover (27) on shift panel (9) with six screws (26).

3-1234