TM-9-2320-273-10
TRUCK, TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; OPERATOR’S MANUAL
DECEMBER 2012
TM-9-2320-273-10 - Page 259 of 452
AFTER FORDING
NOTE
All models can ford up to 20 in. (51 cm) for five minutes
without maintenance for vehicle to continue operation.
1. During fording, water may enter vehicle or its components and contaminate the
fluid systems. Ensure any accumulated water is removed from vehicle before it
causes damage to systems, surfaces, or equipment.
2. As soon as possible after fording, check vehicle using the following guidelines:
a.
Let the engine run for sufficient time to drive out any accumulated water.
b.
Drain or dry areas on vehicle where water has accumulated.
c.
Check each fluid system in vehicle for evidence of water contamination. If
water is found in one or more fluid systems, notify your supervisor to drain,
flush, and refill the contaminated system.
d.
Notify your supervisor of any necessary service or repairs before returning
vehicle to normal use, refer to After Fording in WP 0034.
e.
Notify your supervisor if lubrication is needed after fording is complete,
refer to Lubrication Instructions in WP 0035.
END OF TASK
END OF WORK PACKAGE
TM 9-2320-273-10
0019
0019-3/4 blank
Back to Top
