TM-9-2320-273-10
TRUCK, TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; OPERATOR’S MANUAL
DECEMBER 2012
TM-9-2320-273-10 - Page 334 of 452
Table 1. Preventive Maintenance Checks and Services (PMCS) - Continued.
ITEM
NO.
INTERVAL
ITEM TO BE
CHECKED OR
SERVICED
PROCEDURE
EQUIPMENT NOT
READY/AVAILABLE
IF:
32
After
Transmission
NOTE
Perform step a for the
M915 through M920
only.
a. Shut off engine and
let vehicle sit for five
minutes before
checking transmission
oil level. The level
should be between
the ADD and FULL
marks on
transmission dipstick
(Figure 17, Item 1).
If necessary to
service, fill to within
1/4 in. (6.4 mm) of
FULL mark.
NOTE
Perform steps b and c
for the M915A1 only.
The hot check method is
preferred, but oil level
may be checked with
transmission temperature
below 120° F (49° C)
by reading cold run
band on dipstick.
b. With transmission
temperature gauge
120°–250° F
(49°–121° C) while
idling in neutral with
brake applied,
remove dipstick
(Figure 17, Item 1)
and check oil level.
Dipstick
(Figure 17, Item 1)
should read between
high and low mark
on hot run band.
TM 9-2320-273-10
0025
0025-28
Back to Top
