TM-9-2320-280-20-2
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3
JANUARY 1996
TM-9-2320-280-20-2 - Page 360 of 951
4-74. POWER FEED THROUGH STUD REPLACEMENT
This task covers:
a. Removal
b. Installation
1.
Remove nut (1), lockwasher (2), washer (3), leads 6B/6C (4), and starter cable (5), from stud (8).
Discard lockwasher (2).
NOTE
Step 2 applies to all vehicles except M997A2, M1025A2,
M1035A2, M1043A2, M1045A2, and M1097A2.
2.
Remove nut (12), lockwasher (11), washer (10), and battery cables (9) from stud (8). Discard
lockwasher (11).
3.
Remove locknut (6) and stud (8) from battery box (7).
1.
Install stud (8) on battery box (7) with locknut (6).
NOTE
Step 2 applies to all vehicles except M997A2, M1025A2,
M1035A2, M1043A2, M1045A2, and M1097A2 vehicles.
2.
Connect battery cables (9) to stud (8) with washer (10), lockwasher (11), and nut (12). Tighten
nut (12) to 26 lb-ft (35 N
•
m).
3.
Install starter cable (5) and leads 6B/6C (4) to stud (8) with washer (3), lockwasher (2), and
nut (1). Tighten nut (1) to 18-22 lb-ft (24-30 N
•
m).
4.
Apply silicone compound to stud (8), cables (9) and (5), and leads (4), so that all exposed metallic
surfaces are coated.
b. Installation
a. Removal
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two lockwashers (Appendix G, Item 141)
Locknut (Appendix G, Item 75)
Silicone compound (Appendix C, Item 48)
Manual References
TM 9-2320-280-24P
Equipment Condition
• Battery ground cable disconnected (para. 4-73).
• Buss bar removed (para. 4-76).
M997A2, M1025A2, M1035A2, M1043A2,
M1045A2, and M1097A2 only.
TM 9-2320-280-20-2
4-122
Change 3
Back to Top
