TM-9-2320-280-20-2
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3
JANUARY 1996
TM-9-2320-280-20-2 - Page 376 of 951
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Lockwasher (Appendix G, Item 148)
Lockwasher (Appendix G, Item 141)
Two lockwashers (Appendix G, Item 133)
(serial numbers 1 through 99,999)
Two lockwashers (Appendix G, Item 155)
(serial numbers 100,000 and above)
Four plain-assembled nuts
(Appendix G, Item 200) (old configuration)
Four plain-assembled nuts
(Appendix G, Item 199) (new configuration)
Grease (Appendix C, Item 24)
Manual Reeferences
TM 9-2320-280-24P
Equipment Condition
• Battery tray removed (para. 4-80).
• TOW wiring harness removed from power
feed stud and shunt (para. 11-67).
M966, M966A1 M1036, M1045, M1045A1,
M1045A2, M1046, M1046A1, M1121 only.
4-81. SLAVE RECEPTACLE AND CABLE MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
INITIAL SETUP:
1.
Remove capscrew (8), lockwasher (9), slave negative cable (10), and battery negative cable (11)
from shunt (1). Discard lockwasher (9).
2.
Remove nut (7), lockwasher (6), washer (5), battery positive cable (4), and slave positive cable (3)
from power feed stud (2). Discard lockwasher (6).
3.
Remove four plain-assembled nuts (13), capscrews (18), receptacle (19), and cover (17) from battery
box (12). Discard plain-assembled nuts (13).
NOTE
• Prior to removal, tag leads for installation.
• Perform steps 4 through 7 for vehicles with serial numbers 1
through 99,999.
• Perform steps 8 through 10 for vehicles with serial numbers
100,000 and above.
4.
Slide rubber boot (14) back to allow access to slave receptacle (19) connections.
5.
Remove capscrew (21), lockwasher (20), slave negative cable (10) from receptacle (19). Discard
lockwasher (20).
6.
Remove capscrew (16), lockwasher (15), slave positive cable (3) from receptacle (19). Discard
lockwasher (15).
7.
Remove rubber boot (14).
8.
Loosen compression nut (23) on backshell (22) and remove backshell (22) from receptacle (19).
9.
Remove capscrew (21), lockwasher (20), and slave negative cable (10) from receptacle (19). Discard
lockwasher (20).
10.
Remove capscrew (16), lockwasher (15), and slave positive cable (3) from receptacle (19). Discard
lockwasher (15).
a. Removal
TM 9-2320-280-20-2
4-138
Change 3
Back to Top
