TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 478 of 951

5.

Remove three screws (12), clamps (11), antenna cables (4), intercom cable (16), and harness (9)

from windshield (10).

NOTE

• Perform steps 6 through 8 for old configuration.

• Perform steps 9 through 11 for new configuration.

6.

Remove assembled locknut (13), capscrew (19), washer (18), clamp (17), antenna cables (4),

retainer (14), and grommet (15) from body (8). Discard assembled locknut (13).

7.

Remove assembled locknut (1), screw (3), clamp (2), and antenna cables (4) from body (8). Discard

assembled locknut (1).

8.

Remove two capscrews (20), lockwashers (21), clamp (5), ground strap (6), and antenna cables (4)

from antenna (7) and body (8). Discard lockwashers (21).

9.

Remove two assembled locknuts (30), capscrews (23), washers (24), clamps (25), and antenna

cables (4) from reinforcement (22). Discard assembled locknuts (30).

10.

Remove two assembled locknuts (29), capscrews (26), washers (27), clamps (28), and antenna

cables (4) from body (8). Discard assembled locknuts (29).

11.

Remove two assembled locknuts (13), capscrews (19), grommet (15), retainer (14), intercom

cable (16), and antenna cables (4) from body (8). Discard assembled locknuts (13).

12.

Remove two antenna cables (4) from antenna (7).

4-106. ANTENNA CABLES REPLACEMENT (M997, M997A1, M997A2) (Cont'd)

TM 9-2320-280-20-2

4-238.2

Change 3