TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 526 of 951

TM 9-2320-280-20-2

4-119. CONTROL BOX ELECTRICAL PLUG AND RECEPTACLE REPLACEMENT

This task covers:

a. Plug Removal

c. Receptacle Removal

b. Plug Installation

d. Receptacle Installation

INITIAL SETUP:

Applicable Models

Manual References

M996, M996A1, M997, M997A1, M997A2

TM 9-2320-280-24P

Tools

Equipment Condition

General mechanic’s tool kit:

Battery ground cable disconnected (para. 4-73)

automotive (Appendix B, Item 1)

(receptacle only).

a. Plug Removal

1.

Turn and pull plug (4) from receptacle (3).

2.

Remove two screws (5) from plug (4). Open plug (4) and ensure positive (10), negative (12), and

ground (11) leads for plug (4) are properly installed.

b. Plug Installation

1.

Close plug (4) and install two screws (5) on plug (4).

2.

Insert plug (4) on receptacle (3).

c. Receptacle Removal

NOT E

For instructions on replacement of rivets, refer to para. 10-66.

1.

Remove two rivets (6) and receptacle (3) from control box (1). Pull receptacle (3) away for access to

leads (2).

NOT E

Prior to removal, tag leads for installation.

2.

Loosen screw (8) and push shield (9) away for access to leads (2).

3.

Remove two screws (7), and leads (2) from receptacle (3).

d. Receptacle Installation

1.

Install two leads (2) on receptacle (3) with two screws (7). Position shield (9) over screws (7) and

tighten screw (8).

2.

Install receptacle (3) on control box (1) with two rivets (6).

4-280