TM-9-2320-280-20-3

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3

JANUARY 1996

TM-9-2320-280-20-3 - Page 1039 of 1168

TM 9-2320-280-20-3

D-66

Change 1

Section II.

I L L U S T R ATED MANUFACTURING INSTRUCTIONS (Cont'd)

INSTRUCTIONS:

1. Remove left splash shield. (Refer to para. 10-17.)

2. Cut hole (2) in left splash shield (1) as shown.

3. Using fabricated access cover (6) as a template, locate, mark, and drill a 0.312-inch diameter hole (5)

through left splash shield (1) as shown.

NOTE

Existing mounting hardware is used to secure bottom right-hand hole.

4. Secure top two holes of access cover (6) to left splash shield (1) with two NSN 5306-00-225-8499

washers (4), NSN 5306-00-225-8499 screws (7), NSN 5310-00-087-7493 washers (4), and

NSN 5310-00-814-0673 nuts (3) as shown.

5. Install modified left splash shield. (Refer to para. 10-17.)

Figure D-87. Left Splash Shield.

LEFT SPLASH SHIELD

SPLASH SHIELD

CUT

MANUFACTURED FROM

PART NUMBER

(INCHES)

PART NUMBER

12446771

AS SHOWN

12340361