TM-9-2320-280-20-3
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3
JANUARY 1996
TM-9-2320-280-20-3 - Page 384 of 1168
11-92. RIFLE MOUNTING CLAMP BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038, M1038A1,
M1042, M1097, M1097A1, M1097A2, M1123
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two locknuts (Appendix G, Item 70)
Two locknuts (Appendix G, Item 122)
Manual References
TM 9-2320-280-24P
Equipment Condition
Rifle mounting clamp removed (para. 11-91).
NOTE
Replacement procedures for the front and rear (rear bracket
installed on M1025, M1025A1, M1025A2, M1026, M1026A1,
M1043, M1043A1, M1043A2, M1044, and M1044A1 vehicles only)
rifle mounting clamp brackets are basically the same. This
procedure covers the right front and right rear bracket (M1025A2
only).
1.
Remove two locknuts (5), washers (3), capscrews (4), washers (3), and clamp bracket (2)
from “A” beam (1).
Discard locknuts (5).
NOTE
Perform step 2 for M1025A2 vehicles only.
2.
Remove two locknuts (6), washers (7), capscrews (9), washers (7), and clamp bracket (8)
from “B” pillar (10). Discard locknuts (6).
1.
Install clamp bracket (2) on “A” beam (1) with two washers (3), capscrews (4), washers (3), and
locknuts (5).
NOTE
Perform step 2 for M1025A2 vehicles only.
2.
Install clamp bracket (8) on “B” pillar (10) with two washers (7), capscrews (9), washers (7), and
locknuts (6).
b. Installation
a. Removal
TM 9-2320-280-20-3
11-134
Change 2
Back to Top
