TM-9-2320-280-20-3

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3

JANUARY 1996
TM-9-2320-280-20-3

  TM-9-2320-280-20-3 - Page 843 of 1168

12-146. REAR RADIO RACK TO TOWER ANTENNA CABLES REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
M998, M998A1, M1038, M1038A1
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two locknuts (Appendix G, Item 79)
Three lockwashers (Appendix G, Item 135)
Manual References
TM 9-2320-280-24P
NOTE
Antenna cables from rear radio rack to left or right antenna
towers are replaced basically the same. This procedure covers the
left antenna cables.
1.
Remove two locknuts (7), washers (8), capscrews (10), washers (8), and insulation retainer (9) from
radio rack (5). Discard locknuts (7).
2.
Remove two screws (1) and retainer (2) from cargo floor (6) and left brace (11) and pull
insulation (3) away from radio rack (5).
3.
Remove three screws (13),
clamps (14), and two antenna cables (4) from wheelhouse (16) and cargo
floor (6).
4.
Remove three nuts (17), lockwashers (18), clamps (15), and two antenna cables (4) from tower
capscrews (19). Discard lockwashers (18).
5.
Disconnect two antenna cables (4) from antenna (12).
1.
Connect two antenna cables (4) to antenna (12) and route in approximate mounting location.
2.
Install three clamps (15) and antenna cables (4) on tower capscrews (19) with three
lockwashers (18) and nuts (17).
3.
Install three clamps (14) on two antenna cables (4) and install three clamps (14) on wheelhouse (16)
with screws (13).
4.
Route antenna cables (4) under insulation (3) and install insulation (3) and retainer (2) on cargo
floor (6) and left brace (11) with two screws (1).
5.
Install insulation retainer (9) on radio rack (5) with two washers (8), capscrews (10) washers (8),
and locknuts (7). Tighten capscrews (10) to 15 lb-ft (20 N
•
m).
b. Installation
a. Removal
TM 9-2320-280-20-3
12-230
Change 2


Back to Top