TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 285 of 1258

TM 9-2320-280-34

4-10.

ACCELERATOR CABLE MOUNTING BRACKET MAINTENANCE

This task covers:

a.

Removal

c.

Installation

b.

Inspection

INITIAL SETUP:

Tools

Equipment Condition

General mechanic's tool kit:

Hood raised and secured (TM 9-2320-280-10).

automotive (Appendix G, Item 1)

Maintenance Level

Manual References

Direct support

TM 9-2320-280-10

TM 9-2320-280-20

TM 9-2815-237-34P

a.

Removal

1.

Loosen two nuts (7) and disconnect cable assembly (1) from accelerator bracket (5).

2.

Disconnect throttle return spring (2) from bracket (5).

3.

Remove stop collar (6) and disconnect cable assembly (1) from fuel injection pump (4).

4.

Remove nut (8) and washer (9) from fuel injection pump (4) and stud (11).

5.

Remove two capscrews (10) and bracket (5) from fuel injection pump (4).

b.

Inspection

Inspect throttle return spring (2) for damage. Replace if defective.

c.

Installation

1.

Install bracket (5) on fuel injection pump (4) and stud (11) with washer (9) and nut (8).

2.

Install bracket (5) on fuel injection pump (4) with two capscrews (10). Tighten capscrews (10) to

13 lb-ft (18 N m).

3.

Position throttle shaft lever (3) to full throttle position and secure cable assembly (1) to throttle

shaft lever (3) with stop collar (6).

4.

Connect throttle return spring (2) to bracket (5).

5.

Install cable assembly (1) to bracket (5) with two nuts (7).

4-20