TM 9-2320-283-34-1
3-22.
STARTER MOTOR AND SOLENOID REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
E.
CALIBRATION.
82.
Plug (1).
Remove from item (10).
83.
Four cables (89),
Connect as shown.
Items (7), (8), (10),
battery (91), and
(14), (16), (61), and
switch (90).
(76) are already in-
stalled.
NOTE
Make gage bar by cutting a piece of 3/16" square bar stock to a length
approximately 6" long.
84.
Switch (90).
Set to ON.
85.
Driver (92), shaft
a.
Insert items (92) and
Adjustment is made by
(9), drive (42),
(93) as shown.
turning item (9) with
washer (35), and
item (92).
housing (36).
b.
Adjust spacing so that
clearance at points
indicated is approximately
3/16 inch.
c.
Remove items (92) and
(93).
86.
Plug (1).
Install into item (10).
NOTE
Follow-on maintenance action required:
Install starter (TM 9-2320-283-20).
3-196