TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 344 of 570
TM 9-2320-283-34-2
SPRINGS, SHOCK ABSORBERS, AND TORQUE RODS.
3-103. EQUALIZER BEAM REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
16. End of beam (6).
Using hydraulic jack, lower
away from item (5).
17. Bushing (20).
Using item (lo), press out
of item (6).
Discard item (20).
18. Beam (6).
Clean and inspect end bushing Refer to paragraphs 3-4
bore.
and 3-5.
Be sure to
check for scoring and
wear.
19. New bushing (20).
Using item (10), press into
item (6).
Make sure item (20) is
centered in item (6).
20. End of beam (6).
Using hydraulic jack, raise
until center of item (20) is
lined up with bracket in
item (5).
21. Sleeve (18) and
Install into items (5) and
two adapters (17). (6).
Adjust hydraulic jack as
needed to install two
items (18) and item
(17).
22. Screw (19),
Install into two items (17).
washer (16), and
Torque nut to 210-240
lb-ft.
nut (15).
23. Beam (6) and axle
Remove hydraulic jack and
assembly (5).
jack stand.
24. Dual tires.
Install.
Refer to TM 9-2320-283-
10.
NOTE
Follow-on maintenance action required:
None.
3-900
Back to Top
