TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

TM-9-2320-328-13-P-1 - Page 192 of 1318

TM 9-2320-328-13&P-1

0023-2

DRAFT

0023

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

6.

FOAM SYSTEM switch (1) is in off position.

Indicator light (2) will be out.

END OF TASK

INSTRUMENT PANEL - STANDBY MODE

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

Be sure to wear proper eye protection to prevent injury or death.

Open and close all

valves slowly during any procedure.

Sudden changes in pressure may cause

equipment to react faster than personnel can be alerted.

Ensure surrounding

personnel are aware of changes being made to settings on equipment.

Failure to

comply may result in serious injury or death to personnel and damage to

equipment.

NOTE

For operation of pump, most controls and procedures will be the same whether pumping

from tank, draft, or hydrant.

Operator must ensure that:

1.

ALL water discharge valve controls are in CLOSED position.

2.

ALL water inlet valve controls are in CLOSED position.

3.

ALL drains are in CLOSED position.

4.

ALL foam controls are in CLOSED/OFF position.

5.

ALL inlet and outlet ports capped.

HWT0491

WARNING

ICON 26,66