TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

TM-9-2320-328-13-P-1 - Page 932 of 1318

TM 9-2320-328-13&P-1

0083-2

DRAFT

0083

Change 1

HWT0959

CAUTION

•

Pump must be primed when operating water pump.

Failure to prime pump before

operating water pump may cause damage to equipment.

•

Engine must be at idle before engaging PTO.

Failure to comply will result in

damage to PTO and/or transmission.

Step 2.

Start engine (TM 9-2320-422-10).

Put pump PTO switch to on position (WP 0004).

Put

HIGH IDLE switch to on position (WP 0004).

Enable pump operator’s panel pressure

governor control (WP 0017).

Prepare system to pump from onboard water tank

(WP 0019).

Push pump operator’s panel TANK FILL & RE-CIRCULATING LINE valve

control OPEN button (WP 0004).

Operate system until pump reaches operating

temperature.

Check if pump operator’s panel PUMP HOT indicator

illuminates (WP 0004).

If PUMP HOT indicator does not illuminate, fault has been corrected.

Notify

Supervisor.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION