TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 1085 of 1390

TM 9-2320-328-13&P-2

0288-3

DRAFT

0288

Change 1

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

6.

Remove four nuts (23), lockwashers (24), eight washers (25), four screws (26), and bracket (12) from pump

house frame (13).

Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

Perform Steps (1) and (2) if bracket was removed.

1.

Install bracket (12) on pump house frame (13) with four screws (26), eight washers (25), four

lockwashers (24), and nuts (23).

2.

Install pressure governor ECU service connector (22) on bracket (12) with four screws (21), washers (20),

lockwashers (19), and locknuts (18).

3.

Install pressure governor ECU (4) on bracket (12) with four screws (17), eight washers (16), and four

locknuts (15).

HWT3410