TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 300 of 1390

TM 9-2320-328-13&P-2

0130-8

DRAFT

0130

GENERAL INSPECTION INSTRUCTIONS

a.

Cleaning.

Clean all parts before inspection.

Check for defects such as physical distortion, wear, cracks, and pitting.

b.

Sealing Surfaces.

Inspect all surfaces in contact with gaskets, packings, or seals for nicks and burring.

If any defect is found,

remove it before assembly.

c.

Tubing, Hoses, and Fittings.

Inspect all hose surfaces for broken or frayed fabric.

Check for breaks caused by sharp kinks or contact with

other parts of the vehicle.

Inspect fittings, tubing, mating surfaces, and threads for nicks, cracks, scratches,

and other damage.

Replace any defective part.

After assembly and during initial vehicle operation periods,

check for leaks.

d.

Electrical Parts.

Inspect all wiring harnesses for broken, chafed, or burned wiring.

Inspect all terminal connectors for loose

connections and broken parts.

GENERAL INSTALLATION INSTRUCTIONS

a.

Preparation.

When unpacking items, remove all packing material, barrier paper, tape, plastic bags, protective caps, and

protective grease coatings. Handle and store removed components carefully.

b.

Sealing Compounds.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful

vapors, and are harmful to skin and clothing.

To avoid injury or death, keep away

from open fire and use in well-ventilated area.

If adhesive, solvent, or sealing

compound gets on skin or clothing, wash immediately with soap and water.

CAUTION