TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 301 of 1390

TM 9-2320-328-13&P-2

0130-9

DRAFT

0130

d.

Identification Tags.

Put hoses, tubes, lines, and electrical wiring in place by matching identification tags and markings on

equipment.

e.

Hoses, Air Lines, and Wiring.

After installing hoses, air lines, and wiring, ensure that they do not contact moving parts or component edges.

Secure in place, out of way, with cable ties and cushion clips.

f.

Hose and Fitting Tightening Procedures.

NOTE

Tighten hoses and fittings as required in WP 0387 or in each maintenance task.

If a

torque wrench and crowsfoot are not available or cannot be used, use the following

procedure.

1.

Install hose (1) on fitting (2).

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

- -

-

-

-

-

-

-

-

-

-

-

HWT0175