TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 909 of 1390

TM 9-2320-328-13&P-2

0256-5

DRAFT

0256

NOTE

•

Note routing of intercom power supply wire harness prior to removal to ensure proper

installation.

•

Note position and remove split loom as required.

13. Remove nut (27), lockwasher (28), and intercom power supply wire harness black wire (29) from ground

terminal block (30).

Discard lockwasher.

14. Remove nut (31), lockwasher (32), and intercom power supply wire harness red wire (33) from 12 VDC

terminal block (34).

Discard lockwasher.

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

15. Remove intercom power supply wire harness (5) from vehicle.

END OF TASK

INSTALLATION

NOTE

•

Perform Steps (1) through (7) if intercom bracket and/or power supply wire harness were

removed.

•

Route intercom power supply wire harness as noted prior to removal.

•

Install split loom as required.

1.

Position intercom power supply wire harness (5) on vehicle.

2.

Install intercom power supply wire harness red wire (33) on 12 VDC terminal block (34) with lockwasher (32)

and nut (31).

3.

Install intercom power supply wire harness black wire (29) on ground terminal block (30) with lockwasher (28)

and nut (27).

HWT2441