TM-9-2320-341-10
TRUCK, TRACTOR, LIGHT EQUIPMENT TRANSPORTER (LET), 8X8 M983A4 LET
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-341-10 - Page 308 of 962
NOTE
•
The operator may notice the vehicle mounted (manual) control winch
control lever mimicking the inputs applied to remote-control unit
winch control lever. This is a normal condition.
•
Ensure tension is kept on winch cable at all times during winch cable
retrieval. This accompanied with guidance from the assistant will
ensure the winch cable gets evenly wrapped onto winch drum.
5.
Push in remote-control unit winch control lever (5) as assistant routes winch cable (2)
onto winch drum (6).
6.
Once winch cable (2) is completely and evenly wrapped onto winch drum (6), release
remote-control unit winch control lever (5).
NOTE
If high idle was not utilized during winch cable pay out, skip to Step (8).
7.
Set remote-control unit HIGH IDLE switch (4) to OFF position (as applicable).
8.
Assistant connects clevis retention chain (7) to clevis (8).
9.
Set HYD ENABLE switch (9) to off position. Indicator light (10) will go out.
Alison
10
9
Figure 11.
10. Set HD WINCH REMOTE POWER switch (11) to OFF position.
TM 9-2320-341-10
0042
0042-14
Back to Top
