TM-9-2320-342-10-1

TRUCK, WRECKER, 8X8 M984A4

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-342-10-1 - Page 1253 of 1428

REMOVE LIMP HOME SETUP FROM NO. 3 AND NO. 4 AXLE TIRES - Continued

NOTE

•

If 7 ft. (2.1 m) chain can be disconnected, skip to Step (9).

•

If 7 ft. (2.1 m) chain is too tight to disconnect, continue with Step (5).

•

Removal of limp home setup No. 4 axle is shown. Removal of limp

home setup for No. 3 axle is done in same manner.

5.

Remove two wheel chocks (4), jack base plate (5), and jack (6) from stowage.

4

6

5

Figure 26.

6.

Install two wheel chocks (WP 0097) (4) in front of and behind tire across (on same

axle) from tire in which limp home setup is being installed.

CAUTION

Jack placement is critical to avoid damaging vehicle suspension

components. Follow jack placement notes and procedures carefully.

Failure to comply may result in damage to equipment.

NOTE

•

Jack ram should be fully screwed down (making jack as short as

possible) for Step (7).

•

Center jack on flat spot in center of transverse beam casting.

7.

Place jack base plate (5), and jack (6) under transverse beam casting (7).

TM 9-2320-342-10-1

0108

0108-21