TM-9-2320-343-10
TRUCK, CARGO, 8X8 M985A4 W/WINCH AND M985A4 W/O WINCH
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-343-10 - Page 84 of 1128
Table 4.
Significant Hazard And Safety Recommendations. - Continued
HAZARD
SAFETY RECOMMENDATION
OR PRECAUTION
OPERATING CONDITION
NOTE
•
Material handling cranes have overload shutdown and/or tilt warn-
ing (unstable) systems. Always apply PARKING BRAKE control
(WP 0045) prior to crane operation.
•
When cranes are overloaded, the overload system will automati-
cally shut off power to telescope boom out, raise boom, or hoist load
higher. The overload system will also prevent lowering the boom.
An overload condition can be corrected by lowering load to ground
or other supporting surface. All crane functions will be restored in
approximately six seconds.
NOTE
•
The crane operating instruction plates are located on the heater
compartment cover in the cab and at each of the fixed operating
station.
•
The outrigger leg plates are located on each of the outrigger cylin-
ders.
METRIC SYSTEM
The equipment described herein contains metric components and requires metric, common,
and special tools. Therefore, metric units and English units will be used throughout this
publication. An English-to-metric conversion table is included as the last page of this manual
inside the back cover.
END OF WORK PACKAGE
TM 9-2320-343-10
0001
0001-10
Back to Top
