TM-9-2320-361-10

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

OPERATOR'S MANUAL

DECEMBER 1988

TM-9-2320-361-10 - Page 145 of 392

TM 9-2320-361-10

2-19. USING SLAVE RECEPTACLE TO START ENGINE

a.

Position right side of slaving (recharging) vehicle to right side of disabled

vehicle.

b.

Shutoff slaving vehicle engine.

CAUTION

When slaving, always connect slave cable to disabled

vehicle first Damage to batteries or cable may result

from improperly connecting cable.

NOTE

Make sure electrical switches on both vehicles are in

OFF position.

c.

Remove cover (2) from slave receptacle (3) and connect slave cable (1) to slave

receptacle (3) on disabled vehicle. Repeat procedure on slaving vehicle.

d.

Start slaving vehicle engine and set idle speed at 1000-1100 rpm.

e.

Start slaved vehicle engine.

f.

After engine starts and is running smoothly, disconnect slave cable (1) from

both vehicles.

g.

Put covers (2) back on receptacles (3).

h.

Clean and stow slave cable (1).

i.

Observe battery/generator indicator (4) on slaved vehicle. If indicator (4) does

not reach green area, notify maintenance personnel.

2-20. OPERATION OF VEHICLE SERVICE LIGHTS

Select and set light switch for lighting required. See following chart for switch

positions.

WARNIN G

When hazard warning light.detergency flashers are

in use, they override brake lights/stop lamp operation.

Therefore, when driving with hazard warning lights/

emergency flashers operating, be prepared to use hand

signals to indicate a stop. Failure to do so may result in

injury or death to personnel.

2-88