TM-9-2320-361-10

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

OPERATOR'S MANUAL

DECEMBER 1988

TM-9-2320-361-10 - Page 226 of 392

TM9-2320-361-10

2-32. OPERATION OF EARTH BORING AND POLESETTING

MAINTENANCE TRUCKS (Contd)

(9)

To stop winch from turning, depress clutch pedal (5), and release

accelerator pedal (8).

(10)

Move power divider control lever (7) to NEUTRAL and release clutch

pedal (5).

WARNING

Do not pull back on winch control lever during hoisting

operations, or load may drop and cause injury or death to

personnel.

(11)

If load is attached to cable (2);

(a)

Depress clutch pedal (5).

(b)

Place power divider control lever (7) in REAR WINCH REV.

(c)

Release clutch pedal (5), lower load and remove cable (2).

(12)

Lower derrick (3) if raised (refer to c. of this para.) and remove cable (2)

from sheave (1) (refer to h. of this para.).

(13)

Depress clutch pedal (5), place power divider control lever (7) in REAR

WINCH FWD, and slowly release clutch pedal (5) to wind in cable (2).

(14)

Place rear winch control lever (4) in neutral, and secure.

(15)

Place transmission gearshift lever (6) in “N” (neutral) position and

disengage transfer power takeoff lever (9).

e. Installing Augers.

(1)

To install 9-inch, 12-inch, and 16-inch augers (13):

(a)

Lift locking handle (10), remove holding pin (12), and lift auger (13)

from holder (11).

2-165