TM-9-2320-361-10

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

OPERATOR'S MANUAL

DECEMBER 1988

TM-9-2320-361-10 - Page 227 of 392

TM 9-2320-3061-10

2-32. OPERATION OF EARTH BORING AND POLESETTING

MAINTENANCE TRUCKS (Contd)

(b)

Install rubber bumper (2) and bumper spring (3) on rack bar (1).

(c)

Install auger (4) on rack bar (1) with pin (6) and cotter pin (5).

WARNING

Do not attempt to remove 20-inch and 30-inch augers by

hand. Use rear winch and boring machine derrick to lift and

lower augers. Failure to do this may result in injury or death

to personnel.

(2)

To install 20-inch and 30-inch augers (4):

(a)

Pull out cable (13) (refer to d. of this para.) and wind under, around,

and over strap sheave (12), and over derrick sheave (8).

(b)

Start engine (refer to para. 2-14 or 2-15), raise derrick (7) (refer to c. of

this para.), and position cable (13) directly over auger (4).

(c)

If seat (9) gets in the way of derrick (7), remove safety pin (10), retainer

pin (11), and seat (9).

2-166