TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 377 of 1207

TM 9-2320-361-20

3-33. ACCELERATOR PEDAL, BRACKETS, AND ROD MAINTENANCE (Contd)

10. Connect swivel (9) to pump lever (12) with pin (11) and new cotter pin (4).

11. Position control wire (7) through flange on accelerator rod (8) and install connector (6) and

screw (5) on control wire (7). Do not tighten. Position connector (6) 0.125 in. (0.32 mm) from

flange on accelerator rod (8) and tighten screw (5).

12. Install throttle return clip (1) on steering gear housing (13) with washer (2) and screw (3).

13. Install spring (10) on throttle return clip (1) and swivel (9).

c. Adjustment

1.

2.

3.

4.

5.

Remove locknut (15) from threaded stud (16) and disconnect threaded stud (16) of ball

from lever (17).

Loosen nut (19) on accelerator rod (14).

joint (18)

NOT E

Rod is shortened by turning ball joint clockwise on rod and

lengthened by turning ball joint counterclockwise on rod.

Shorten or lengthen accelerator rod (14) until threaded stud (16) of ball joint (18) will

into hole of lever (17).

Install locknut (15) on threaded stud (16).

Tighten nut (19) on rod (14).

freely slide

3-74