TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 379 of 1207
TM 9-2320-361-20
3-34. ENGINE STOP CONTROL CABLE MAINTENANCE
This task covers:
a. Removal
c. Adjustment
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Four lockwashers
EQUIPMENT CONDITION
Cotter pin
Parking brake set (TM 9-2320-361-10).
Tiedown strap (Appendix C, Item 20)
Hood raised and secured (TM 9-2320-361-10).
a. Removal
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove tiedown strap (8) and engine stop control cable (1) from around steering column (9).
Remove nut (19), two lockwashers (12), and screw (13) from clamp (16). Discard lockwashers (12).
Straighten end of control cable wire (11) and loosen screw (10) on swivel (21).
Remove control cable wire (11) and control cable (1) from swivel (21) and clamp (16).
Remove cotter pin (18), swivel (21) and screw (10) from fuel shutoff valve (20). Discard cotter
pin (18).
Remove screw (14), lockwasher (15) and clamp (16) from fuel injection pump (17). Discard
lockwasher (15).
Loosen nut (6) behind instrument panel (5) and slide nut (6) and lockwasher (3) back on control
cable (1).
Pull engine stop control (4) out from instrument panel (5) and remove nut (6) and lockwasher (3)
from cable (1) as end of cable (1) comes through grommet (7) in firewall (2). Discard lockwasher (3).
Remove grommet (7) from firewall (2).
1. Install grommet (7) on firewall (2).
2. Route end of engine stop control (4) through instrument panel (5).
3. Position new lockwasher (3) and nut (6) on end of control cable (1) and insert control cable (1)
through grommet (7) and firewall (2).
4. Install engine stop control (4) on instrument panel (5) with lockwasher (3) and nut (6).
5. Install clamp (16) on fuel injection pump (17) with new lockwasher (15) and screw (14).
6. Install swivel (21) on fuel shutoff valve (20) with new cotter pin (18) and install screw (10) on
swivel (21). Do not tighten.
7. Slide control cable (1) through clamp (16) and control cable wire (11) through swivel (21).
8. Install two new lockwashers (12), screw (13), and nut (19) on clamp (16). Do not tighten nut (19).
1. Push ENGINE STOP control (4) all the way in.
2. Pull fuel shutoff valve (20) out (toward firewall).
3-76
Back to Top
