TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 587 of 1207

TM 9-2320-361-20

8-4. PARKING BRAKE CABLE REPLACEMENT (Contd)

1.

2.

3.

4.

5.

6.

7.

8-14

CAUTION

Be careful when installing parking brake cable to ensure there are

no sharp bends or kinks.

Install parking brake cable (4) on bracket (6), with spacer (1) and clamp (2) on groove of parking

brake cable (4), with two screws (3) and nuts (5).

Install wear plate (9) on parking brake cable (4), approximately 12 in. (30.5 cm) from bracket (6),

with clamps (8) and (11), four screws (7), and nuts (10). Do not tighten nuts (10).

Install threaded end (12) of brake cable (4) through eye of lever (16), and install nut (13) up to

marked location on threaded end (12).

Place clamp (18) on parking brake cable (4) and install clamp (18) on transfer case (17) with new

lockwasher (19) and screw (20).

Install spring (14) on lever (16) and bracket (15).

Install parking brake cable (4) on frame (23) with upper clamp half (22), lower clamp half (25), two

screws (21), and nuts (24).

Adjust position of wear plate (9) to protect parking brake cable (4) from rubbing on edge of toolbox.

Tighten nuts (10).