TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 589 of 1207
TM 9-2320-361-20
8-5. PARKING BRAKE LEVER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Cotter pin
EQUIPMENT CONDITION
Wheels chocked (TM 9-2320-361-10).
PERSONNEL REQUIRED
Two
1. Release parking brake if applied (refer to TM 9-2320-361-10).
2.
Remove cotter pin (4), washer (3), and clevis pin (15) from cable clevis (12) and parking brake
lever (1). Discard cotter pin (4).
3. Remove four nuts (6) and bracket (10) from cab floor (9) and two parking brake lever mounting
brackets (7).
NOTE
Assistant will help with step 4.
4. Remove nut (11), screw (8), and parking lever (1) from cab floor (9).
5. Remove nut (5) and screw (13) from spacer (2) and two parking brake lever mounting brackets (7).
6. Remove two nuts (14), screws (16), and parking brake lever mounting brackets (7) from parking
lever (1).
b. Installation
NOTE
Ensure parking brake lever adjusting knob is turned counter-
clockwise to lower link for installation.
1. Install two parking brake lever mounting brackets (7) on parking brake lever (1) with two
screws (16) and nuts (14). Do not tighten nuts (14).
2. Install spacer (2) and screw (13) between two parking brake lever mounting brackets (7) and parking
brake lever (1) with nut (5). Tighten nuts (5) and (14) so that parking brake lever (1) moves freely.
NOTE
Assistant will help with step 3.
3. Install parking brake lever (1) on cab floor (9) with screw (8) and nut (11).
4. Install bracket (10) on cab floor (9) and two parking brake lever mounting brackets (7) with four
nuts (6).
5. Connect parking brake lever (1) to cable clevis (12) with clevis pin (15), washer (3), and new cotter
pin (4).
8-16
Back to Top
