TM-9-2320-361-34

TM 9-2320-361-34

15-6.

CAB PROTECTOR MAINTENANCE (Contd)

Cleaning and Inspection

1. Inspect cab protectors (17) and (11) for cracks, dents, and rust. Repair if damaged (FM 43-2 and

TM 9-237).

2. Clean and paint as necessary (TB 43-0209 and TM 43-0139).

c. Installation

1. Install chains on cab protector brackets (14) with two screws (12), washers (13), and nuts (15).

Install lifting device on chains.

2. Install guide line on cab protector bracket (14).

3. Position upper cab protector (17) on lower cab protector (11) and install two pins (1), four

washers (2), and new cotter pins (3) through two hinges (16).

4. Install upper cab protector (17) on lower cab protector (11) with four screws (4) and nuts (5).

WARNING

10.

11.

12.

All personnel must stand clear during lifting operations. A swinging

or shifting load may cause injury to personnel.

Position upper and lower cab protectors (17) and (11) on dump body (8).

Install lower cab protector (11) on dump body (8) with eight screws (10) and new locknuts (9).

Remove lifting device from chain. Remove two nuts (15), washers (13), screws (12), and chains from

cab protector brackets (14).

Remove guide line from cab protector bracket (14).

Remove four screws (4) and nuts (5) from upper and lower cab protectors (17) and (11).

NOTE

Assistant will help with step 10.

Tilt upper cab protector (17) over cab.

Install four screws (19) and new locknuts (18) on upper and lower cab protector brackets (14).

Install three screws (6) and new locknuts (7) on lower cab protector (11) and dump body (8).

15-22

TM-9-2320-361-34 - Page 333 of 764