TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 331 of 764
TM 9-2320-361-34
15-6.
CAB PROTECTOR MAINTENANCE
THIS TASK COVERS:
a.
Removal
c. Installation
b.
Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
M342A2
TOOLS
General mechanic’s tool kit (Appendix B, Item 1)
Lifting device
Two screws (Appendix F, Item 213)
Two locknuts (Appendix F, Item 106)
Four washers (Appendix F, Item 268)
MATERIALS/PARTS
Fifteen locknuts (Appendix F, Item 105)
Four cotter pins (Appendix F, Item 7)
PERSONNEL REQUIRED
REFERENCES (TM)
FM 43-2
TB 43-0209
TM 9-237
TM 9-2320-361-10
TM 9-2320-361-34P
TM 43-0139
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
GENERAL SAFETY INSTRUCTIONS
All personnel must stand clear during lifting
operations.
Tw o
a. Removal
Remove three screws (6) and locknuts (7) from cab protector (10) and dump body (20). Discard
locknuts (7).
2.
3.
4.
5.
6.
7.
WARNIN G
8,
9.
10.
11.
12.
13.
Remove four screws (19) and locknuts (18) from upper and lower cab protector brackets (13).
Discard locknuts (18).
NOTE
Assistant will help with step 3.
Tilt upper cab protector (17) over top of
lower cab protector (10) and install on lower cab
protector (10) with
four screws (4) and nuts (5).
Install chain on lower cab protector brackets (13) with two screws (11), washers (12), washers (14),
and locknuts (15).
Install guide line on cab protector (17).
Install lifting device on chain and remove slack from chain.
Remove eight
screws (9) and locknuts (8) from lower cab protector (10) and dump body (20). Discard
locknuts (8).
All personnel must stand clear during lifting operations. A shifting
or swinging load may cause injury to personnel.
Remove upper and lower cab protectors (17) and (10) from dump body (20) and place on wooden
supports.
Remove four nuts (5) and screws (4) horn upper and lower cab protectors (17) and (10).
Remove four cotter pins (3), washers (2), and two pins (1) from two hinges (16). Discard cotter
pins (3).
Lift upper cab protector (17) away from lower cab protector (10) and place on wooden supports.
Remove lifting device from chain. Remove two nuts (15), screws (11), two washers (14), washers (12)
and chain from lower cab protector brackets (13).
Remove guide line from cab protector (17).
15-20
Back to Top
