TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 481 of 764

TM 9-2320-361-34

15-42. INTERMEDIATE CASE MAINTENANCE

(Contd)

d. Intermediate Gear Assembly

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

Pack bearings (8), (12), (21), and (27) with GAA grease.

NOTE

●

When

bearing

is

installed,

bearing shield must face gear.

●

Install

all

new

shims

to

thickness

previously

measured.

Install new shims (28), bearing (27), adjusting nut (25), and retaining ring (26) on second reduction

drive pinion (30).

Install spacer (24), new shims (23), two new woodruff keys (29), drive gear (22), bearing (21),

adjusting nut (19), and retaining ring (20) on second reduction drive pinion (30).

Pack twenty-four roller bearings (31) with GAA grease and install bearings (31) in second reduction

drive pinion (30).

Install second reduction feed pinion (32) in second reduction drive pinion (30).

Install new shims (18) and gear and hub (17) on second reduction drive pinion (30).

Install new shims (16), bearing retainer (13), bearing (12), adjusting nut (11), and retaining ring (9)

on gear and hub (17).

Install new shims (10), bearing (8), nut (6), and new cotter pin (7) on shaft of second reduction feed

pinion (32).

Install cap (5) on bearing retainer (13) with six new lockwashers (15) and screws (14).

Install new gasket (4) and cap cover (3) on cap (5) with four new lockwashers (2) and screws (1).

15-170