TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 551 of 764

TM 9-2320-361-34

16-2. FRONT WINCH REPAIR (Contd)

e.

Front Winch Gearcase Assembly

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

12.

Install bearing (9) in gearcase (1).

Install bearing (2) on worm gear shaft (8).

Position worm gear shaft (8) in gearcase (1) and through bearing (9). Tap bearing (2) until seated.

Install new seal (10) in brakecase (11).

Install new gasket (14) and brakecase (11) on gearcase (1) with four new lockwashers (13) and

screws (12).

Install new seal (3) in bearing cap (4).

Install new gasket (7) and bearing cap (4) on gearcase (1) with four new lockwashers (6) and

screws (5).

Install dial indicator on gearcase (1) with plunger positioned on the end of worm gear shaft (8).

Measure end play of worm gear shaft (8) by moving worm gear shaft(8) back and forth. End play

should not be less than 0.005 in. (O.127 mm).

Remove dial indicator from gearcase (1).

NOTE

If end play is correct, go to step 13. If end play is incorrect, go to

step 11.

Remove four screws (5), lockwashers (6), and bearing cap (4) from gearcase (1). Discard lock-

washers (6).

Perform steps 7 through 10 to install additional gasket (7).

16-8