TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 545 of 764
TM 9-2320-361-34
16-2. FRONT WINCH REPAIR
(Contd)
a. Front Winch Disassembly
1. Remove four screws (4), lockwashers (5), and channel (3) from gearcase (7) and end frame (12).
Discard lockwashers (5).
2. Remove six screws (2), lockwashers (1), and channel (6) from gearcase (7) and end frame (12).
Discard lockwashers (1).
3. Remove locknut (13) and end frame (12) from rod (9) and drum shaft (10). Discard locknut (13).
4. Remove plug (11) from end frame (12).
5. Remove plug (8) from gearcase (7).
I
b. Front Winch End Frame Disassembly
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
16-2
Remove six screws (48), lockwashers (47), washers (46), and spacers (45) from end frame (12).
Discard lockwashers (47).
Remove drum sliding clutch (37), thrust ring (36), and seal (39) from end frame (12). Discard
seal (39).
Remove adjusting screw (44), spring (42), and drag brakeshoe (41) from end frame (12).
Remove plug (34) and setscrew (33) from end frame (12).
Remove setscrew (38) from shifter fork (35).
Remove shifter fork (35) and woodruff key (24) from shifter shaft(31) while removing shifter
shaft (31), ball (29), and spring (28) from end frame (12). Discard woodruff key (24).
Remove screw (27), lockwasher (26), lever (25), and woodruff key (30) from shifter shaft (31).
Discard lockwasher (26) and woodruff key (30).
Remove screw (23), lockwasher (22), plate (21), and seal (32) horn end frame (12). Discard lock-
washer (22) and seal (32).
Remove two nuts (14), poppet latch (15), poppet nut (16), spring (17), and poppet (18) from end
frame (12).
Remove plug (19), three plugs (20), and pin (43) from end frame (12). Discard pin (43).
Remove sleeve (40) from end frame (12).
Back to Top
