TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 535 of 764
TM 9-2320-361-34
15-52. PIPELINE CONSTRUCTION TOOLBOX REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M756A2
W/W
TM 9-2320-361-10
TOOLS
TM 9-2320-361-20
TM 9-2320-361-34P
General mechanic’s tool kit
(Appendix B, Item 1)
EQUIPMENT CONDITION
1-1/8-in. socket, 1/2-in. dr. (Appendix B, Item 10)
●
Bow and tarp kit removed (TM 9-2320-361-10).
1-1/16-in. socket, 1/2-in. dr. (Appendix B, Item 11)
●
Side panels removed (TM 9-2320-361-20).
Torque wrench, 1/2-in. dr. (Appendix B, Item 7)
. Step plate removed (TM 9-2320-361-20).
Lifting device
●
Front splash guard removed (TM 9-2320-361-20).
MATERIALS/PARTS
GENERAL SAFETY INSTRUCTIONS
Six locknuts (Appendix F, Item 89)
●
All personnel
must
stand
clear
during lifting
Eight locknuts (Appendix F, Item 104)
operations.
Six locknuts (Appendix F, Item 103)
. Toolbox is heavy. Ensure toolbox is empty and
PERSONNEL REQUIRED
supported before removal and installation.
Two
a. Removal
1.
Remove four locknuts (9), locknuts (11), eight washers (8), and screws (2) from two brackets (12) and
four brackets (7). Discard locknuts (9) and (11).
2.
3.
4.
5.
6.
7.
8.
Remove four locknuts (6) and screws (2) from two plates (4) and frame (10). Discard locknuts (6).
Loosen two locknuts (5).
Remove six locknuts (13) and screws (1) from toolbox (15) and two subframe brackets (14). Discard
locknuts (13).
WARNING
●
All
personnel
must stand clear during lifting operations. A
swinging or shifting load may cause injury to personnel.
●
Toolbox is heavy. Ensure toolbox is empty before removing from
frame. Support toolbox during removal. Failure to do so may
result in injury to personnel.
CAUTION
Do not lift, subframe 0.5 in. (1.27 cm) above frame. Damage to
equipment may result.
NOTE
Assistant will help with lifting operations.
Attach lifting device and chains to subframe (3).
Raise subframe (3) from frame (10) 0.5 in. (1.27 cm) maximum.
Remove toolbox (15) from frame (10).
Lower subframe (3) and remove chains from lifting device and subframe (3).
15-224
Back to Top
