TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 531 of 764

TM 9-2320-361-34

15-51. PIPELINE CONSTRUCTION

BODY MAINTENANCE (Contd)

I

b.

Flooring Removal

NOTE

Mark location of floorboards for proper installation.

1. Remove fourteen screws (2), washers (3), locknuts (10), two slats (4), and board (1) from

subframe (9). Discard locknuts (10).

2. Remove twenty-one screws (2), washers (3), locknuts (10), three slats (11), (6), and (4), two

boards (5), board (7), and board (8) from subframe (9). Discard locknuts (10).

3. Remove twenty-one screws (2), washers (3), locknuts (10), four slats (4), and three boards (5) from

subframe (9). Discard locknuts (10).

c. Inspection

1. Inspect boards (1), (5), (7), and (8) for warpage, rot, and splits that exceed board width. Replace if

warped, rotted, or splits exceed board width. Inspect two boards (1) for 1.31 in. (3.33 cm) thickness.

Replace if thickness is not correct.

2. Paint parts as needed (TB 43-0209).

I

e. Flooring Installation

1. Position two boards (1), boards (7) and (8), and five boards (5) on subframe (9) and install with seven

slats (4), forty-nine screws (2), washers (3), and new locknuts (10).

2.

Install two slats (11) and (6) on boards (7) and (5) and subframe (9) with seven screws (2),

washers (3), and new locknuts (10).

15-220