TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 529 of 764

TM 9-2320-361-34

15-51. PIPELINE CONSTRUCTION BODY MAINTENANCE

(Contd)

I

a. Subframe Removal

NOTE

Perform step 1 if installing new subframe.

1.

2.

3.

4.

5.

6.

7.

8.

Remove six locknuts (19), four screws (1), and two screws (3) from toolbox (20) and two brackets (2)

from subframe (6). Discard locknuts (19).

Remove eight locknuts (13), washers (12), four screws (4), and screws (5) from two brackets (18),

brackets (7), frame brackets (14), and frame brackets (15). Discard locknuts (13).

Remove six locknuts (9), four screws (17) and two screws (16) from two plates (8) and frame (11).

Discard locknuts (9).

Attach chains, lifting device, and guide lines to subframe (9).

WARNING

.

All personnel must stand clear during lifting operations. A

swinging or shifting load may cause injury to personnel.

●

Toolbox and subframe are heavy. Ensure lifting device has a

weight capacity greater than the weight of the toolbox and

subframe. Failure to do so may result in injury to personnel or

damage to equipment.

Remove subframe (6) from toolbox (20) and frame (11) and place on wooden supports.

Remove lifting device and chains from subframe (6).

WARNING

Toolbox is heavy. Ensure toolbox is empty before removing from

frame. Support toolbox during removal. Failure to do so may result

in injury to personnel.

NOTE

Perform step

7

if installing new subframe.

Remove toolbox (20) from frame (11).

Remove and inspect two fillers (10) for splitting and wear. Replace if split or worn.

15-218