TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 727 of 764

TM

9-2320-361-34

APPENDIX E (Contd)

Tubing

Application

Tightening

Assmbly Instructhns

Slide

tubing

over barbed insert until it bottoms on

MINI-BARB

fitting.

1. Slide nut and then sleeve on tubing.

2.

Slide I.D. of tubing onto fitting insert until it

bottoms.

3.

Assemble nut b fitting body.

4. Tighten assembly finger tight to cover body

1.

2.

3.

4.

Slide nut and then sleeve on tubing.

Slide I.D. of tubing onto fitting insert until it

bottoms.

Assemble nut to fitting body .

Tighten assembly finger tight to cover body

threads.

1. Cut tubing to desired length. Ensure ends are

cut

reasonably square.

2.

Slide tubing into the preassembled fitting and

push until tube bottoms.

3. Tighten nut as indicated in chart. Another

check on proper assembly is dimension “A,”

when nut is fidly tightened.

REASSEMBLY- Push tubing and insert into

DISASSEMBLY

— Remove nut and pull tubing

out of fitting body. Insert will remain on tubing.

fitting body until it bottoms. Thread nut onto

fitting body and tighten as in step 3.

E-4