TM-9-2320-362-14-P

TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)

TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)

APRIL 1992

TM-9-2320-362-14-P - Page 104 of 353

TM 9-2320-362-14&P

3-31. POWER INTERFACE BOX REPAIR (Cont’d)

e. Power Terminals Cover Removal

1.

File small flat on rivet heads (4) on power terminals cover side of

hinge (3).

2.

Center punch flats while supporting rivet backsides (4).

WARNING

When drilling,

be sure to wear goggles for eye

protection or injury to personnel may occur.

3.

Using 3/16-inch drill bit,

drill through rivet heads (4) on power

terminals cover side of hinge (3),

4.

Unlatch clamping catch (1) from strike (5).

5.

Remove two screws (7) and lockwashers (6) from strike (5). Remove

strike (5) and cover (2).

Discard lockwashers (6).

f. Power Terminals Cover Installation

1.

Place cover (2) in position.

2.

Place hinge (3) in position.

3.

Rivet hinge (3) to cover (2).

4.

Install strike (5) to cover (2) and

lockwashers (6).

5.

Close cover (2) and fasten clamping

secure with two screws

catch (1) to strike (5)

(7) and

3-7 4