TM-9-2320-362-14-P
TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)
TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)
APRIL 1992
TM-9-2320-362-14-P - Page 88 of 353
TM 9-2320-362-14&P
3-26. CABLE ASSEMBLY W66 REPLACEMENT (Cont’d)
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
From engine side, route wire no.
28 (14) through cowl grommet (20).
Slide rubber shell (15) and plastic sleeve (16) from connector (12)
onto wire no.
28 (14).
Strip insulation l/4-inch (0.64 cm) from end of wire no. 28 (14).
Install connector terminal (17) onto wire no. 28 (14) and crimp.
WARNING
To prevent eye injury, wear protective eye wear
while performing any soldering.
Solder crimped joint between connector terminal (17) and wire
no. 28 (14).
Slide plastic sleeve (16) and rubber shell (15) onto connector
terminal (17).
Install wire no.
28 (14) to 3-way connector (19).
Connect safety lanyard (10) to safety tab (2).
Connect cable assembly W66 (11) to connector on back of tach/hourmeter
box (3).
Install engine access cover (4) and secure with two ring studs (5).
Secure two engine access cover holddown latches (8) to engine access
cover holddown strikes (l).
Secure two flexible latches (9) to keepers (7) on engine access cover
holddown brackets (6).
Place instrument cluster (18) in position and secure with four
screws (13).
3-5 8
Back to Top
