TM-9-2320-362-14-P
TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)
TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)
APRIL 1992
TM-9-2320-362-14-P - Page 90 of 353
TM 9-2320-362-14&P
3-27. CABLE ASSEMBLY REPAIR
NOTE
For basic cable assembly repairs, see TM 9-2320-280-20.
3-28. WIRE NO. 798 REPLACEMENT
This task covers:
a: Removal
b. Installation
INITIAL SETUP:
Tools
Equipment Condition
General mechanic’s tool kit:
●
Hood raised and secured
automotive (Item 1, Section III,
(TM 9-2320-280-10)
Appendix B)
●
Battery ground cable disconnected
Material/Parts
(TM 9-2320-280-20)
Tie-straps P/N MS3367-2-0
Manual References
TM 9-2320-280-10
TM 9-2320-280-20
1.
2.
3.
4.
5.
6.
7.
8.
9.
3-60
Unlatch two flexible latches (13) from keepers (11) on engine
access cover holddown brackets (10).
Unlatch two engine access cover holddown latches (12) from engine
access cover holddown strikes (19).
Turn two ring studs (7) and pull engine access cover (6) out
until end of safety lanyard (14) is reached.
Disconnect cable assembly W66 (16) from connector on tach/hourmeter
box (5).
Unhook safety lanyard (14) from safety tab (1).
Remove engine access
cover (6).
Remove tie-straps (4) that attach wire no. 798 (8) to wiring
harness (3).
Remove wire no. 798 (8) from wire no. 798 (9) (on compressor).
Remove screw (15) that attaches loop clamp (18), wire no. 798 (8),
wire no. 58 (17), and safety tab (1) from engine block (2).
Remove wire no. 798 (8).
Back to Top
