TM-9-2320-365-20-3

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-3 - Page 721 of 1268

TM 9-2320-365-20-3

Change 2

9-2.3

e. Installation.

(1)

Install two grease fittings (1) in universal joint (2).

(2)

Position universal joint (2) on drive shaft (3) with

two bearing cups (4) and four screws (5).

WARNING

CAUTION

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

Wipe end of yoke bearing bores prior to

installation.

NOTE

There are two types of bearing cups, those

with tabs and those without. Perform the

following step on bearing cups not

equipped with tabs.