TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 519 of 1414

TM-9-2320-365-34-2

Change 2

10-8.1

(18.2) Remove drive shaft (22.1) from frame (22.2).

(19) Position universal joint (23) on drive yoke (24) with

two bearing cups (25) and four screws (26).

(19.1) Tighten four screws (26) to 26-35 lb-ft (35-47 N•m).

WARNING

CAUTION

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups in ensure all needle

bearings are in place prior to installation.

replace bearing cups if needle are missing or

out of place.

Failure to comply may result in

damage to equipment.

NOTE

•

Wipe end of yoke bearing bores prior to

installation.

•

There are two types of bearing cups,

those with tabs and those without.

Perform step (19) on bearing cups not

equipped with tabs.

NOTE

Perform step (19.1) on kits equipped with

screws P/N C5 H5-24-39.