TM 9-2320-365-34-2
Change 2
18-55
18-5.
ENHANCED RESILIENT MOUNT INITIAL INSTALLATION
This task covers:
a. Mechanical Stop Resilient Mount Removal
b. Mechanical Stop Resilient Mount Installation
c. Front Leaf Spring Resilient Mount Removal
d. Front Leaf Spring Resilient Mount Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Gravel deflector removed (TM 9-2320-365-10).
Cab raised (TM 9-2320-365-10).
Front leaf spring removed (front leaf spring resilient
mount only) (TM 9-2320-365-34)
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Drill Set, Twist (Item 17, Appendix B)
Drill, Portable Electric (Item 18, Appendix B)
Wrench, Torque 0-200 lb-in (Item 81, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 90, Appendix B)
Wrench, Torque 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
C-Clamp (Item 10, Appendix B)
Jack, Dolly Type, Hydraulic (Item 31, Appendix B)
Trestles, Motor Vehicle Maintenance (2) (Item 71,
Appendix B)
Tools and Special Tools (Cont)
Crowfoot Attachment, Socket Wrench (Item 14,
Appendix B)
Vise, Machinist (Item 72, Appendix B)
Socket, Left Front Spring, U-Bolt (Item 8,
Appendix D)
Materials/Parts
Bolt, U (2) (Item 15.1, Appendix F)
Nut, Self-locking (5) (Item 133, Appendix F)
Nut, Self-locking (4) (Item 124, Appendix F)
Nut, Self-locking (2) (Item 138, Appendix F)
Nut, Self-locking (2) (Item 134, Appendix F)
Pin, Cotter (Item 230, Appendix F)
Sealing Compound (Item 75, Appendix C)
Grease, Automotive and Artillery (Item 36,
Appendix C)
a. Mechanical Stop Resilient Mount Removal.
(1)
Remove two self-locking nuts (1), bolts (2), and
mechanical stop (3) from frame (4).
Discard self-
locking nuts.
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
NOTE
Both mechanical stops are removed the
same way.
Right rear side shown.