TM 9-2320-365-34-2
18-52
Change 2
18-4.
DIGITIZATION KIT INITIAL INSTALLATION (CONT)
(161) Remove two nuts (195), lockwashers (196), washers
(197), and cover (198) from terminal block TB1 (199).
Discard lockwashers.
(162) Install terminal lug TL22 (193) on terminal block TB1
connector 58 (200).
(163) Install terminal lug TL22 (194) on terminal block TB1
connector 58 (200).
(164) Install two washers (197) and cover (198) on terminal
block TB1 (199) with two washers (197), lockwashers
(196), and nuts (195).
(165)
Remove screw (201) and lockwasher (202) from
24 VDC connector X1 (203).
Discard lockwasher.
(166)
Install terminal lug TL20 (204) on 24 VDC
connector X1 (203) with lockwasher (202) and
screw (201).
NOTE
•
Perform steps (162) through (164) on
vehicle serial numbers 00001 through
11437.
•
Perform step (162) on vehicles equipped
with WTEC II transmission controllers.
NOTE
Perform step (163) on vehicles equipped
with WTEC III transmission controllers.
NOTE
Other terminal lugs are present at this
location.